If you wrap pallets by hand, choose 500mm hand stretch film in 25 micron. It handles most mixed loads and sharp carton corners. Choose machine stretch film (17–23 micron on long rolls) only if you run a wrapping machine. Use clear pallet wrap when staff need to read labels, and black when you want to keep stock out of sight.
Pallet wrap vs stretch wrap
They are the same product. Pallet wrap, stretch wrap, stretch film and pallet stretch film are all names for the thin, stretchy polyethylene film that is wound around a loaded pallet. As it is stretched, the film pulls tight and clings to itself, holding the cartons together so the load does not shift on the forklift or the truck. It also keeps dust and moisture off the stock.
It is often called shrink wrap, but true shrink wrap is a different product: it goes on loosely and is then heated so it shrinks tight. Stretch wrap needs no heat, which makes it faster and cheaper for everyday warehouse work.
Hand vs machine stretch film
| Hand stretch film | Machine stretch film | |
|---|---|---|
| How it is applied | By hand, walking around the pallet, or with a hand dispenser | On a turntable or robot wrapping machine that pre-stretches the film |
| Roll size (our range) | 500mm wide, 280–400m long, light enough to carry | 500mm wide, 1,305–1,733m long, loaded onto the machine |
| Thickness | Usually 23–25 micron | Usually 17–23 micron |
| Best for | A few pallets a day, odd-shaped loads, wrapping in different spots | Many pallets a day, even loads at a fixed wrapping station |
| Strengths | No equipment needed, easy to start | Even tension, less film per pallet, less strain on staff |
Don't swap them. Machine rolls are too long and heavy to use by hand, and the thinner film relies on the machine's pre-stretch for strength. Hand rolls are too short to run efficiently on a machine.
Which micron should I buy?
Thickness is measured in microns (written u, um or µm). One micron is a thousandth of a millimetre.
| Thickness | Typical use |
|---|---|
| 17 micron | Machine wrapping light, even loads; longer rolls mean fewer roll changes |
| 20–23 micron | Standard machine film for most loads; lighter hand wrapping |
| 25 micron | Hand wrapping mixed, heavier or sharp-cornered loads; our standard hand roll |
Thicker is not always better. A thinner film applied with steady tension and good overlap can hold a load better than a thick film wrapped loosely. Match the film to the load, then focus on technique.
Cast vs blown pallet wrap
Stretch film is made in two main ways, and each has its own strengths:
- Cast film: clear and glossy, unwinds quietly and smoothly, and is easy to see through for scanning barcodes. Our standard 500mm x 285m clear hand rolls suit everyday pallets.
- Blown film: tougher, with better resistance to punctures and tears, and strong cling. It is a little hazier and noisier to unwind. Choose it for sharp edges and irregular loads, like our 500mm x 400m blown hand pallet wrap.
Clear or black pallet wrap?
- Clear: staff can read labels, scan barcodes and count cartons without unwrapping. The default choice for most warehouses.
- Black: hides what is on the pallet, which helps deter theft and keeps light off stock. Popular for electronics, retail stock and anything valuable. See our black hand pallet wrap.
For small bundles such as pipes, timber lengths or a few cartons, a full 500mm roll is overkill. Use 100mm bundling film instead.
How to wrap a pallet
- Anchor the tail. Tuck the end of the film under the bottom layer of cartons or tie it to a pallet corner.
- Lock the base. Make 3–4 tight wraps around the bottom, covering the top of the pallet deck so the load is tied to the pallet.
- Spiral up. Walk upwards, overlapping each layer by about half the film width and keeping the tension steady.
- Secure the top. Wrap the top layer twice so cartons can't slide off.
- Finish. Come back down a little, cut the film and press the tail flat so it clings.
Avoid over-stretching at the corners, where the film is most likely to tear. If you wrap more than a handful of pallets a day, a hand dispenser reduces waste and strain, and a wrapping machine with machine stretch film may pay for itself.
Clear and black hand rolls, machine stretch film and bundling film, delivered Australia-wide or picked up from Minto, NSW and Braeside, VIC. Pallet lots of up to 200 rolls available.
Pallet wrap FAQs
Is stretch wrap the same as pallet wrap?
Yes. Stretch wrap, stretch film and pallet wrap all describe the same stretchy film used to hold loads on a pallet.
Is pallet wrap the same as shrink wrap?
No. Pallet wrap holds the load by stretch and cling at room temperature. Shrink wrap is applied loosely and then heated so it shrinks tight.
What micron pallet wrap should I use?
For hand wrapping, 25 micron suits most loads, including heavy or sharp-cornered ones. Machine film is usually 17–23 micron because the machine pre-stretches it.
Can I use machine stretch film by hand?
It is not practical. Machine rolls are long and heavy, and the film is designed to be pre-stretched by the machine. Use hand stretch film for manual wrapping.
Can I buy pallet wrap in bulk?
Yes. Hand rolls come singly or in cartons of 2 or 4, with wholesale lots of 80 or 200 rolls, and machine film in lots of 50 rolls. Contact us for a bulk quote.
